Turning your Raspberry Pi into a security surveillance camera is a cheap alternative to setting up a security system in your house or office. The Raspberry Pi 3 is more then powerful to capture video with the Official Raspberry Pi camera. Today we will be installing MotionEye on our Raspberry Pi to turn it into a security camera. We will be able to view live video in our browser as well as auto record videos when motion is detected. This is great for saving precious space on our microSD card and only keeping the videos we need. We can also save the videos and delete them after a set amount of time. Setting up a Raspberry Pi security camera with MotionEye is very easy and works right out of the box with the default settings.
We will also be able to setup a network of security cameras with multiple Raspberry Pi’s and monitor all of camera over one interface. If cost and space is an issue it is possible to upload all our videos to your Dropbox or Google Drive account for easy access anywhere. This is a great low cost solution to building a security system in your house and you can also use it as an outdoor system as well to monitor your front door. There are a ton of Raspberry Pi compatible cameras you can use for the Raspberry Pi security camera and the choice is your’s depending on your needs. You can use the official Raspberry Pi camera that plugs into the camera port or you can use an old webcam that you have laying around and plug it into the USB port.
To build a Raspberry Pi security surveillance camera system that is run and controlled over your own network
You will need the following:
- Raspberry Pi
- 8GB Micro SD Card (Bigger SD card if you plan on saving the video to the SD card)
- 2.5A Power Supply
Let’s get started. We will first need to install our camera onto the Raspberry Pi by plugging it into the camera port. I am using the official NOIR Raspberry Pi camera in this tutorial, however you can use whatever camera is compatible with the Raspberry Pi. Plug your camera’s ribbon cable into the camera ribbon slot on the Raspberry Pi board, the camera ribbon port is the one located behind the Ethernet port. You your fingers to pull up on both sides of the connector to open it up and insert the ribbon cable with the metal leads facing away from the Ethernet port. Once the ribbon cable is seated all the way inside the connector you can push down on the connector to lock the camera’s ribbon cable in place. It is important that the metal leads face away from the Ethernet port or your camera may not work or even worse it can be shorted. Continue Reading